Commands by edmondblake25 (0)

  • …
    bash: commands not found

What's this?

commandlinefu.com is the place to record those command-line gems that you return to again and again. That way others can gain from your CLI wisdom and you from theirs too. All commands can be commented on, discussed and voted up or down.

Share Your Commands

Check These Out

Convert seconds to [DD:][HH:]MM:SS
Converts any number of seconds into days, hours, minutes and seconds. sec2dhms() { declare -i SS="$1" D=$(( SS / 86400 )) H=$(( SS % 86400 / 3600 )) M=$(( SS % 3600 / 60 )) S=$(( SS % 60 )) [ "$D" -gt 0 ] && echo -n "${D}:" [ "$H" -gt 0 ] && printf "%02g:" "$H" printf "%02g:%02g\n" "$M" "$S" }

List your MACs address

Increase SCT of external USB disk enclosure to one hour.
So I had this 2TB Seagate external disk/USB enclosure which by default would spin-down its internal drive (it enters a standby mode) after four minutes of inactivity.. Spinning-up the inactive drive was an annoying delay when accessing files and also it severely interfered with NFS.. SCT stands for "Standby Condition Timer". To completely disable SCT: $ sdparm --clear STANDBY -6 /dev/sdb To return to original (default) SCT settings: $ sdparm -D -p 0x1a -6 /dev/sdb To verify the settings (before and after): $ sdparm -a /dev/sdb No need for vendor-provided MSWIN tools, etc.

How to check network connection from one interface
This command only check the network connection from given eth. This is very useful if you are using more then one interface in your server or laptop.

Run a bash script in debug mode, show output and save it on a file
Sends both stdout and stderr to the pipe which captures the data in the file 'out.test' and sends to stdout of tee (likely /dev/tty unless redirected). Works on Bourne, Korn and Bash shells.

Rebuild a Delimited File with a Unique Delimiter
Useful for CSV files. In the command, the file in question is comma delimited but contains double quoted fields containing commas and contains no @ symbols (as confirmed with http://www.commandlinefu.com/commands/view/9998/delimiter-hunting). This command converts the delimiting commas to @s while preserving the commas in the fields using the "uniqueString" to mark the ends of lines.

Get a process's pid by supplying its name

Check variable has been set

Command to keep an SSH connection open
This runs the uptime command every 30 seconds to avoid an SSH connection dropping due to inactivity. Granted there are better ways of solving this problem but this is sometimes the right tool for the job.

Display 6 largest installed RPMs sorted by size (descending)
Low on disk space? Check the largest installed RPMs for delete canditates.

Stay in the loop…

Follow the Tweets.

Every new command is wrapped in a tweet and posted to Twitter. Following the stream is a great way of staying abreast of the latest commands. For the more discerning, there are Twitter accounts for commands that get a minimum of 3 and 10 votes - that way only the great commands get tweeted.

» http://twitter.com/commandlinefu
» http://twitter.com/commandlinefu3
» http://twitter.com/commandlinefu10

Subscribe to the feeds.

Use your favourite RSS aggregator to stay in touch with the latest commands. There are feeds mirroring the 3 Twitter streams as well as for virtually every other subset (users, tags, functions,…):

Subscribe to the feed for: