Enable Synology Debug mode on shell
admin@ds-2:~$ synogear
Tools are installed and ready to use.
DiagnosisTool version: 3.0.1-3004
usage: synogear <command>
The most commonly used commands are:
install Get and run this package, also load all tools
remove Remove it
help Show this usage
list List all tools
check Check if tools are ready to use
Examples:
1. synogear install
Install debug tools and load them into environment
2. synogear remove
Remove tools and restore all settings
3. synogear list
List all loaded tools
What do you think?
Any thoughts on this command? Does it work on your machine? Can you do the same thing with only 14 characters?
You must be signed in to comment.
What's this?
commandlinefu.com is the place to record those command-line gems that you return to again and again. That way others can gain from your CLI wisdom and you from theirs too. All commands can be commented on, discussed and voted up or down.
Similar Commands
Stay in the loop…
- Follow the Tweets.
-
Every new command is wrapped in a tweet and posted to Twitter. Following the stream is a great way of staying abreast of the latest commands. For the more discerning, there are Twitter accounts for commands that get a minimum of 3 and 10 votes - that way only the great commands get tweeted.
» http://twitter.com/commandlinefu
» http://twitter.com/commandlinefu3
» http://twitter.com/commandlinefu10 - Subscribe to the feeds.
-
Use your favourite RSS aggregator to stay in touch with the latest commands. There are feeds mirroring the 3 Twitter streams as well as for virtually every other subset (users, tags, functions,…):
Subscribe to the feed for:
- » all commands
- » commands with 3 up-votes (commandlinefu3)
- » commands with 10 up-votes (commandlinefu10)