Check These Out
To rip DVD movie to ogg format using ffmpeg, follow these steps.
1) find the vob files on the mounted video DVD in VIDEO_TS that stores the movie itself. There would be a few other VOB files that stores splash screen or special features, the vob files for the movie itself can be identified by its superior size. You can verify these vob files by playing them directly with a player (e.g. mplayer)
2) concatenate all such vob files, pipe to ffmpeg
3) calculate the video size and crop size. The ogg video size must be multiple of 16 on both width and height, this is inherit limitation of theora codec. In my case I took 512x384.
The -vcodec parameter is necessary because ffmpeg doesn't support theora by itself. -acodec is necessary otherwise ffmpeg uses flac by default.
swap out "80" for your port of interest. Can use port number or named ports e.g. "http"
NR%2 == 1 on odd lines and 0 on even lines
This command first determines whether a second screen is connected. If this is the case, it sets the screen's RGB gamma via xrandr. Useful for cheap or slightly defective monitors with a tint. In this example a yellowing/champagne color deviation is compensated for by decreasing the red and the green portion of the image.
I've kept the gzip compression at a low level, but depending on the cpu power available on the source machine you may want to increase it. However, SQL compresses really well, and I found even with -1 I was able to transfer 40 MiB/s over a 100 mbps wire, which was good enough for me.
You might want to secure your AWS operations requiring to use a MFA token. But then to use API or tools, you need to pass credentials generated with a MFA token.
This commands asks you for the MFA code and retrieves these credentials using AWS Cli. To print the exports, you can use:
`awk '{ print "export AWS_ACCESS_KEY_ID=\"" $1 "\"\n" "export AWS_SECRET_ACCESS_KEY=\"" $2 "\"\n" "export AWS_SESSION_TOKEN=\"" $3 "\"" }'`
You must adapt the command line to include:
* $MFA_IDis ARN of the virtual MFA or serial number of the physical one
* TTL for the credentials
Knock on ports to open a port to a service (ssh for example) and knock again to close the port. You have to install knockd.
See example config file below.
[options]
logfile = /var/log/knockd.log
[openSSH]
sequence = 3000,4000,5000
seq_timeout = 5
command = /sbin/iptables -A INPUT -i eth0 -s %IP% -p tcp --dport 22 -j ACCEPT
tcpflags = syn
[closeSSH]
sequence = 5000,4000,3000
seq_timeout = 5
command = /sbin/iptables -D INPUT -i eth0 -s %IP% -p tcp --dport 22 -j ACCEPT
tcpflags = syn
