This converts any media ffmpeg handles to flash. It would actually convert anything to anything, it's based on the file extension. It doesn't do ANY quality control, sizing, etc, it just does what it thinks is best. I needed an flv for testing, and this spits one out easily.

If the remote doesn't export its desktop (eg fluxbox, blackbox etc) then you need to run a x11vnc server there and a vncviewer at the local end. This command does the lot for you - it assumes that you can 'ssh' to the box without a password and that x11vnc is installed at the remote end.

If you want to pull all of the files from a tree that has mixed files and directories containing files, this will link them all into a single directory. Beware of filesystem files-per-directory limits.

fade [type] fade-in-length [stop-time [fade-out-length]] Apply a fade effect to the beginning, end, or both of the audio. An optional type can be specified to select the shape of the fade curve: q for quarter of a sine wave, h for half a sine wave, t for linear (`triangular') slope, l for logarithmic, and p for inverted parabola. The default is logarithmic. A fade-in starts from the first sample and ramps the signal level from 0 to full volume over fade-in-length sec? onds. Specify 0 seconds if no fade-in is wanted. For fade-outs, the audio will be truncated at stop-time and the signal level will be ramped from full volume down to 0 starting at fade-out-length seconds before the stop-time. If fade-out-length is not specified, it defaults to the same value as fade-in-length. No fade-out is performed if stop-time is not specified. If the file length can be determined from the input file header and length-changing effects are not in effect, then 0 may be specified for stop-time to indicate the usual case of a fade-out that ends at the end of the input audio stream. All times can be specified in either periods of time or sample counts. To specify time periods use the format hh:mm:ss.frac format. To specify using sample counts, specify the number of samples and append the letter `s' to the sample count (for example `8000s').

You might want to secure your AWS operations requiring to use a MFA token. But then to use API or tools, you need to pass credentials generated with a MFA token. This commands asks you for the MFA code and retrieves these credentials using AWS Cli. To print the exports, you can use: `awk '{ print "export AWS_ACCESS_KEY_ID=\"" $1 "\"\n" "export AWS_SECRET_ACCESS_KEY=\"" $2 "\"\n" "export AWS_SESSION_TOKEN=\"" $3 "\"" }'` You must adapt the command line to include: * $MFA_IDis ARN of the virtual MFA or serial number of the physical one * TTL for the credentials