This commands will make it easier to select only common items between two files being compared. If your lines start with things other than lowercase a-z, adjust this Regex appropriately. Number of lines in the output has been set to no more than 10000, and should be adjusted as needed.

Show Sample Output

This is a little bash script that will take all files following the *gz pattern in the directory and apply the tar -zxvf command to them.

No need for -l and the output can be sent directly into another function expecting directory names. Show Sample Output

Similar, but uses tarball instead of zip file

Put in your path (.bashrc or similar). Then instead of running '$ git-commit -m ' use '$ git-random'

Works in all shells. Does not require a test. Handles like an assertion. Show Sample Output

OMG, you are a Gentoo junkie. -funroll-loops-me-harder ;-) http://ccache.samba.org/ ccache is a compiler cache, which speeds up your compiler on successive runs, because it caches intermediate compiled output. Show Sample Output

It is a much better tool then nslookup for getting information about the any site.It has got better capability too.For reverse information please use the switch "-x" and the ip address. Show Sample Output

This will recursively go through every file under the current directory showing all lines containing "TODO" as well as 10 lines after it. The output will be marked with line numbers to make it easier to find where the TODO is in the actual file.

Just tape: sudo -s your passwd startx -- :1

First you need to instal aircrack-ng Use this command if you need to put your wireless card into monitor mode. interface = wlan0 || wifi0 || ath0 et ceatera... channel = 6, 11, 10, 9 et ceatera

This assumes there is only one result. Either tail your search for one result or add | head -n 1 before the closing bracket. You can also use locate instead of find, if you have locate installed and updated

Usually the MS-DOS cmd.exe processes in the whole FOR loop as one command and expands each var like %varname% in before (except the loop var of course). This command enables expansion of other vars than only the loop var during the FOR loop. The syntax of the var to expand is then !varname! inside the FOR loop. Use command endlocal to end the setlocal command. E.g. (only works from batch files, not from commandline directly): @echo off setlocal enabledelayedexpansion FOR %%A IN (*) DO ( set file=%%A echo !file! ) endlocal

Jan Nelson from Grockit came up with this for us when we needed to rename all of our fixtures.

Grep for a TAB . -- www.fir3net.com --

Removing .svn directories without a pipe